Indopoxy IK.930 Epoxy coating is specially formulated coating to use as primer on concrete floors, walls and existing coatings. IK.930 is a two component amine cured solvent free epoxy coating. It is transparent. It ensures very good adhesion on most concrete floors in atmospheric environments. It is resistant to wide range of chemicals including many acids, alkalies, minerals oils, solvents etc.
Indopoxy IK.930 is a coating system recommended for use over cement bound surfaces like concrete, screed and plaster. It can also be applied over iron and steel. It is a primer for Indopoxy IK.990 and other epoxy topcoats. IK.930 is recommended for laboratories, hospitals, food and beverage plants, high tech manufacturing facilities, dairies, warehouses, factories and hangars.
Colour
Transparent (Clear)
Finish
Glossy (70-85GU at 60° angle)
Soild by Volume
98 ± 2%
Flash Point
90° C
Shelf Life
12 months
Recommended film thickness per coat
Dry Film Thickness
50-200μ in single coat
Wet Film Thickness
20-200μ in single coat
Therotical Coverage Rate
10.00 sq.mt / lit at recommended DFT of 100μ
All surfaces to be coated should be clean, absolutely dry and oil or moisture free before painting application. Oil and grease should be removed by solvent cleaning.
New Concrete Surface : Concrete should be cured for a minimum of 30 days prior to coating. The moisture content of the concrete should be below 5%. All surfaces should be clean, dry and free from curing compounds, release agents, trowelling compounds, surface hardeners, grease, oil, dirt, old coatings. All poured and precast concrete must also be sweep blasted (preferred) or acid etched to remove laitence. In fact laitance deposits are best removed by Planetary diamond disc grinder or by captive blasting followed by vacuum cleaning to remove dust debris.
Existing Coating : Old concrete need to check first for adhesion to the substrate and then should be coated with IK.930 primer. To avoid air bubbles, it is very important to pierce the coating with a spiked roller when desired film thickness is achieved.
Application Method
Brush/ Roller
Mixing Ratio
2 Part (Base) : 1 Part (Hardener)
Pot Life
25 min at 30°C
Thinner and Cleaner
Indopoxy Epoxy Thinner (IK.1501)
Download Brochure