This is a one component fast air drying Hammer Tone finish. It has a glossy finish with good gloss retention. To be used in internal areas or in low to mild industrial environments.
This product is recommended as topcoat with suitable primers for better aesthetics and decorative looks. Indofast 4025HT is specially developed finish for fast productivity and better durability than conventional alkyd based hammer finishes. It is recommended on structural steels, casting and forging components such as Electrical Motors and Pumps, Furniture and General fabrication industries for protecting Steel.
Colour
Limited Customized Shades
Finish
Glossy
Soild by Volume
42 ± 3%
Supply Weight (Kg/ Ltr)
1.00±0.05
Flash Point
25° C
Dry Heat Resistance
Intermittent : 60°C
Shelf Life
12 months
Recommended film thickness per coat
Dry Film Thickness
30-50μ in single coat
Wet Film Thickness
70-120μ in single coat
Therotical Coverage Rate
14.00 sq.mt / lit at recommended DFT of 30μ
All surfaces to be coated should be clean, absolutely dry and oil or moisture free before painting application. Oil and grease should be removed by solvent cleaning.
Primed Surface : The primed surface should be dry and free from all contamination and Indofast 4025HT should be applied within the overcoating intervals specified in primer TDS. Area of damaged primer or rework etc should be prepared as per specified standards, either by power tool cleaning or other means.
Bare Steel : Abrasive blast clean to a minimum of Sa2½ (ISO 8501-1:2007). Surface defects revealed by the blast cleaning process should be ground, filled, or treated in the appropriate manner. A surface profile of 30-40 microns is recommended.
Application Method
Conventional Spray, Brush only for small Areas
Mixing Ration
One Component Coating
Pot Life
NA
Thinner and Cleaner
Indokote Thinner (IK.708)
Airless Nozzle Orifice
NA
Nozzle Pressure
NA
Download Brochure