updraftplus domain was triggered too early. This is usually an indicator for some code in the plugin or theme running too early. Translations should be loaded at the init action or later. Please see Debugging in WordPress for more information. (This message was added in version 6.7.0.) in /home1/indoksf5/public_html/wp-includes/functions.php on line 6114A high build high solids, polyamide cured two component epoxy coating use as a high performance intermediate or finish coating. It gives outstanding moisture, chemical and solvent resistance and is Suitable for coastal and industrial atmospheric environments and immersion service. Extremely tough when cured and will resist damage
As a high performance coating for structures in severe environments e.g. Offshore oil platforms, Shiploaders, Coal Plants, Fertilizer Plants, Power & Gas Plants, Oil- Refineries, Ore Handling Projects etc. Indopoxy 645HSHB provides resistance to fresh or salt water, petroleum products, aliphatic solvents, alkalis and other chemical products.
Colour
Reddish Brown & Metallic Grey
Finish
Eggshell to Semi Glossy
Soild by Volume
80 ± 3%
Supply Weight (Kg/ Ltr)
1.85±0.05
Flash Point
34° C
Dry Heat Resistance
Intermittent : 140°C, Continuous : 120°C
Shelf Life
12 months
Recommended film thickness per coat
Dry Film Thickness
100-250μ in single coat
Wet Film Thickness
125-300μ in single coat
Therotical Coverage Rate
5.5 sq.mt / lit at recommended DFT of 150μ
All surfaces to be coated should be clean, absolutely dry and oil or moisture free before painting application. Oil and grease should be removed by solvent cleaning.
Primed Surface : Primers under Indopoxy 645HSHB should be applied over blast cleaned surface to St3 or blast cleaned to Sa2 or better. Existing system should be dry and free from loose paint, salt, grease and other contaminants prior to overcoating.
New steel : For immersion service, 645HSHB must be applied directly to surfaces blast cleaned to a minimum of Sa2½ (ISO 8501-1:1988) SSPC SP10. However However, for atmospheric exposure 645HSHB should be applied over approved anti-corrosive primers. The primer surface should be dry and free from all contamination.
Maintenance : Remove oil and grease etc. thoroughly with suitable detergent. Remove salts and other contaminants by high pressure fresh water cleaning. Clean damaged areas thoroughly by power tool cleaning to St 3 (ISO 8501-1:2007) (minor areas) or by abrasive blasting to min. Sa 2, preferably to Sa 2½ (ISO 8501-1:2007). Improved surface preparation will improve the performance of the product.
Metallic Zinc Primed : To Ensure that the surface of the primer is clean, dry and free from contamination and zinc salts before application of Indopoxy 645HSHB. Ensure zinc primers are fully cured before overcoating.
Application Method
Spray/ Airless Spray/Brush/ Roller
Mixing Ratio
3 Part (Base) : 1 Part (Hardener)
Pot Life
Three Hours at 30°C
Thinner and Cleaner
Indopoxy Epoxy Thinner (IK.1501)
Airless Nozzle Orifice
0.53 - 0.66mm
Nozzle Pressure
211 kg/cm² or 3000 psi
Download Brochure